About: jetskiworld

The illustrated handlepole comes with all necessary hardware for its installation, and the length can be cut in order to achieve better adjustment. It can be installed on a Kawasaki, Yamaha and Hydrospace and it costs 650uero or $800usd. More information on www.amx.si or nalesi@gmail.com

Westcoast head for Kawasaki SXi750. It is in an excellent condition and it is supplied with 26cc domes written on them, would be good for a tall port timing Big Pin 750 or race gas on a small pin cylinder. It was providing 210psi on a small pin engine. It costs $120 + s&h with correct, NEW Westcoast head gasket. Available from WatCon

New updated design for 2018, lighter and now has a hex for easy removal. All Yamaha (Except 63M/66E/66V). Utilizes Kawasaki Dampener Type. Order it from Hot Products USA WITH P/#34-700190

Kommander Industries sells them for $2500. Everything but engine, electrics, start button and throttle lever. It has complete pump, steering , fuel tank, fuel pump etc. Kommander Ind. uses the engine to build the NA and turbo version of the GP1 skis/ Contact Kommander Ind. if you need a brand new Yamaha hull.

These pipes are available from WatCon for a limited time. They have a FEW new Factory pipes for Kawasaki 650SX, and X-2. Orders will be filled in order as they come. Therefore, if you need one make sure you place your order fairly soon. They cost $520 + s&h

The R&D Intake Manifold Ribbon Delete Kit was developed to increase airflow into and through the intake system by relieving restriction. The R&D Intake Manifold Sleeve replaces the OEM intake ribbon producing a 40 CFM increase in air flow. The R&D billet sleeve mounts between the intake manifold and the throttle body creating a superior Venturi effect. The R&D Intake Kit will add low end and mid range throttle response, and a full 100 plus rpms to top end performance to a stock SVHO. The R&D Intake sleeve is an absolute must have part to remove intake restrictions before contemplating power adding compressor booster wheels or turbo charger kits to the Yamaha SVHO engine. True horsepower gains on the Yamaha start right here with the R&D Intake Sleeve. More airflow will equal more power. Note: The Kit comes complete with install jig to cut out the oem ribbon which is molded into the plastic manifold. A 2.750” hole saw (required) is sold separately or available at your local hardware store with part number P/# 612-17996.

Keep your water lines in place and give a custom look in your engine compartment with this new product, Line-loc. It is simple and does the job. Prices are, 1 set=$25 and 2 sets=$40. Combining different colors of Line-loc rings and hoses makes it even more interesting.