Category Archives: NEWS (ENG)

NEWS (ENG)

Kommander Industries sells them for $2500. Everything but engine, electrics, start button and throttle lever. It has complete pump, steering , fuel tank, fuel pump etc. Kommander Ind. uses the engine to build the NA and turbo version of the GP1 skis/ Contact Kommander Ind. if you need a brand new Yamaha hull.

These pipes are available from WatCon for a limited time. They have a FEW new Factory pipes for Kawasaki 650SX, and X-2. Orders will be filled in order as they come. Therefore, if you need one make sure you place your order fairly soon. They cost $520 + s&h

The R&D Intake Manifold Ribbon Delete Kit was developed to increase airflow into and through the intake system by relieving restriction. The R&D Intake Manifold Sleeve replaces the OEM intake ribbon producing a 40 CFM increase in air flow. The R&D billet sleeve mounts between the intake manifold and the throttle body creating a superior Venturi effect. The R&D Intake Kit will add low end and mid range throttle response, and a full 100 plus rpms to top end performance to a stock SVHO. The R&D Intake sleeve is an absolute must have part to remove intake restrictions before contemplating power adding compressor booster wheels or turbo charger kits to the Yamaha SVHO engine. True horsepower gains on the Yamaha start right here with the R&D Intake Sleeve. More airflow will equal more power. Note: The Kit comes complete with install jig to cut out the oem ribbon which is molded into the plastic manifold. A 2.750” hole saw (required) is sold separately or available at your local hardware store with part number P/# 612-17996.

Keep your water lines in place and give a custom look in your engine compartment with this new product, Line-loc. It is simple and does the job. Prices are, 1 set=$25 and 2 sets=$40. Combining different colors of Line-loc rings and hoses makes it even more interesting.

The R&D Power Core Intake Manifold Sleeve Kit was developed to increase airflow into and through the intake system by relieving restriction. The R&D Intake Manifold Sleeve replaces the OEM intake ribbon producing a 40 CFM increase in air flow. The R&D billet sleeve mounts between the intake manifold and the throttle body creating a superior Venturi effect. The R&D Intake Kit will add low end and mid range throttle response, and a full 100 plus rpms to top end performance to a stock SVHO. The R&D Intake sleeve is an absolute must have part to remove intake restrictions before contemplating power adding compressor booster wheels or turbo charger kits to the Yamaha SVHO engine. True horsepower gains on the Yamaha start right here with the R&D Intake Sleeve. More airflow will equal more power. R&D recommends upgrading the Cooling System with R&D Cooling Kit Pt. # 660-18002 and Intercooler Pt. # 612-18006 or 612-18005 for added air flow and power. * Picture displays restictive OEM ribbon (left), R&D Sleeve (center), and R&D Sleeve with OEM Seal (right). Available from R&D with Pt. # 612-17997.

The largest distributor of watercraft parts and accessories, Hot Products USA, plans to launch its famous annual parts catalogue in the Mark Hahn 300 2018 race, which will take place in Lake Havasu city, AZ. If you are visiting Lake Havasu city on the 24th of February make sure that you will not miss the race.

It makes the difference when you build a 440/550/650 hull with a bigger engine in it. It releases the power from the engine and makes the throttle response crispier. Side Exhaust Exit, 1 - 3/4". Could be used on 440, 550, 650sx, X-2, and others. $25 + s&h. For more information contact John at watcon@watcon.com