Category Archives: NEWS (ENG)

NEWS (ENG)

The triple cylinder Series-S Race edition HSR-Benelli is alive and finally, the potential customers had the opportunity to see it live in the International Athens Boat Show. According to the official importers, Aquacraft, the particular model is for sale, though, the final cost has not yet been announced. The pictured final product carries small, but crucial alterations (engine hood front support, water fittings, handle pole assembly, reduction gear box finish, etc), compared to the prototype Ski that was shown at the international press launch in Spain last June. Well done, for the Austrians…

This is the third Chinese pwc seen in Greece in the last two months. The Chinese invasion is an issue and it happens very fast. The pictured vessel is available in three versions and it is equipped with a Suzuki –motorcycle based- engine. The displacement varies from 1100cc to 1400cc and the horse power range from 95hp to 155hp. The design looks very familiar with the Sea Doo XP215, on the other hand, the quality and overall finish is kept at a very low lever. The cost of the three models varies from 6.900-7.900-8.900euros. Read more about the Chinese jet ski’s under the Features section.

This is the new billet aluminum big bore cylinder from SE specially made fro Kawasaki SX-R. It was exposed to the enthusiasts eyes during the World Finals though now is available from SE. This particular set comes with a set of special pistons made by Wiseco and it features a unique craftsmanship to the all ports as well as to the head design. The cylinder itself looks familiar to the PJS Supercylinder we had seen in the past on Factory Kawasaki motors ridden by Kanamori and Sheldon.

Wiseco made the pictured piston especially for FENNEC. These pistons are available in bores of 89, 89.50, 90 and 91mm and they use 22mm pin diameter. Suits Maekawa's Billet Cylinder and S.E.’s Billet Cylinder. They are supplied with rings, pins and cir clips.

This is the adjustable Handle-mount for Kawasaki Ultra250. By loosening 8 allen bolts of the cap-bolt from right to left and 4 allen bolts of the cap-bolt clamping the handlebar, you may adjust the position of your handlebar up and down. You may adjust the height by approximately 50mm. It's made out of high quality billet aluminum. It's easy to install by switching it from the OEM handle post. It's convert from FAT-Bar(28.6mm) to STD-Bar(22.2mm) by using a set of bushings. It is distributed in Japan by Jetwave and in US by Fennec Group Co. Inc.

R&D is doing lots of work on the new Yamaha SHO. According to Bill Chapin “we went 76 miles per hour with the Yamaha SHO by using the R&D intercooler and modified supercharger and the engine had 15 pounds of boost, big intercooler, R&D/VIPEC ECU. We can possibly go 78 with a skat trak 12 vein pump”. Chapin believes that the Yamaha is a beast on the bottom end and has the potential to do even better than that.

The Peruvian Association of Watercrafts has the pleasure of inviting to the Sport Journalism in general to the Conference of Press of Official Presentation of the 8TH World championship of JET SKI to be carried out in our country from November 28TH to December 06 TH. In this same ceremony it will be presented to the Peruvian delegation that will defend the native colors in this international competition in front of the best exponents in the discipline in the world. Day: Wednesday November 19 2008. - Hour: 4:00 PM - Address: Av. Republic of Panama 4344 - Surquillo Place: New local Yamaha Motor of the Peru - We thank your attendance.