Ver.MPI-3 Interface

Ver.MPI-3 Interface
Ver.MPI-3 adapter can be used for diagnostic of all 4-TEC/E-TEC BRP vehicles 2002-2020 and newest: PWC and Sport Boats SeaDoo, Snowmobiles Skidoo and Lynx. All Can Am vehicles (ATV, SSV, Roadster Spyder). This ver.MPI-3 interface consists of MPI-3 electronic board in an another plastic enclosure. BUDS and BUDS2 define it as an MPI-3 interface. Ver.MPI-3 adapter works with BUDS and BUDS2. Also, it works with DIUS4 B.U.D.S. (BRP Utility and Diagnostic Software) is a comprehensive diagnostic software.
Ver. MPI-3 adapter (p/n 529036353) - is used for diagnosis of all BRP vehicles 1996-2020+; Diagnostic Cable (p/n 710000851) - is used for connection of MPI Interface to 4-TEC/E-TEC vehicles; Software BUDS1 for models 1996-2016; BUDS2 license for vehicles 2017+. Choose the type and duration of the BUDS2 license to work with models 2017 and newest. Using BRP BUDS MPI-3 Diagnostic Kit you can make the following procedures:
Edit vehicle information: Test, add or remove DESS keys, Adjust engine parameters, Activate module outputs, Stop the engine, Monitor vehicle parameters, Troubleshoot vehicle faults, Replace a module, Update module software and/or calibration data, Read and reset historical data, Save vehicle information to disk, Print vehicle information.

In addition to the basic capabilities of the license "Dealer", the license "Megatech" allows you to do the following: Change the VIN and MODEL numbers (is useful after ECU replacing), View stories in hours, rather than percentage, Enable/disable DESS (start vehicle with any key (except Roadster Spyder), Change the DESS key type in two clicks (normal, learning, rental), Clear the ECM history (is useful after ECU replacing), Change Total Vehicle Hours (Sea-Doo), View more information blocks, Edit injector's coefficient for E-TEC Skidoo, Enable/disable vehicle’s options/modules/sensors, Increase the power of Spark 60 hp up to 90 hp.
The differences between license levels "Dealer" and "Megatech" can be seen in the comparison table. BUDS1 software will not be updated in the future.

error: Content is protected !!